Node 200 has a good design and very well built. Easy to program with the option of controlling 2 zones with 1 controller.

Purchased this controller for my HOA to replace another Hunter controller that was bad. Price was good, arrived quickly and easy to install and program. Especially like the fact we do not have to run power to the controller since it is battery powered.

Was easy to install to replace the old one

Great product performed as advertised.

when they work they are ok. Last one only lasted three years. I do not care for there programming features. I bought this because there is no power in this location.

Ordered Hunter Node 200. Delivered as promised, on time and was able to install immediately.

I bought this node for a backup and haven't used it yet but at the price I got it for I couldn't resist.

These are pricey little nuggets but effective

Good price and includes wired solenoid. The installation was super easy and only took a moment. It took longer to program than it did to install. Programming isn't bad, just follow the directions, its about as expected. It can operate on one 9v or 2 9v batteries. I always add 2 batteries, but I change them yearly. 2 batteries will run it much longer, but being as these nodes are below ground level and around $100 each, Id rather change batteries yearly than chance having the batteries corrode and ruin a unit. I replaced 3 of these that lasted 9 years...and only replaced them because of neglected corroded batteries.

Ordered a Hunter 2-Node battery operated irrigation control unit to replace an 8 year old identical unit whose LED screen had failed. Ordered on 12-16-24 and it was delivered from Cali on 12-22-24.Installed on 12-23-24.We have three battery operated Hunter irrigation controllers. They are easy to use and operate flawlessly as intended. I highly recommend this Amazon vendor.

Had to install this on a valve not connected to the grid. Was quick and easy. I did have to swap the valve to a hunter one. I could have cut the wires and used the other brands old valve, but wanted to leave them factory sealed. Comes with a mount plate/holder and dust cover.

Installs and Programs easily. Great for a single station application. Runs up to two years off of two 9 volt batteries so no low voltage to wire to it. Works perfectly!

Not easy or intuitive to program. Pain in the rear.

This is my 2nd unit. 1st one lasted over 20 years working perfectly.

It was a great DIY. The instructions were clear, and I was able to remove the old one and replace it with this new one in 20 minutes.

Our old controller had been hit by a lawnmower at least once, so when I attempted ti make adjustments it was impossible. I ordered the new one, installed it, and it works great!n

easy to install

I purchased this Hunter sprinkler controller to replace an older unit that had failed after many years of use. This new replacement controller came with a prewired solenoid as an extra surprise that also replaced the existing solenoid. Installation, consisting of replacing the solenoid, took less than ten minutes. The new controller uses two 9 volt batteries for power in contrast to the old Hunter unit that only used one 9 volt battery. I had to replace the old unit battery about every six to nine months so I am hopeful the new controller will operate for a longer period of time without having to replace the batteries. Programming was identical to the old unit and took me about 15 minutes to program the new Hunter. Maybe it was due to the age of the older unit but the new Hunter controller display was much easier to read and see items displayed. It has operated flawlessly and continuously for two months since it was installed. I will change the programming later in the late fall season and check the battery level at that time. This is a great battery operated sprinkler controller and works very well where you do not have any 110 Volt power source. I find it easier to program than my wired power sprinkler controllers and just as reliable. Do not forget to turn off the water source before removing the old solenoid and controller...........

I was replacing the same Node of an older generation. The newer one came pre-installed to a solenoid, but it would not fit on the older valve. I had to cut all the wiring and splice it into the existing valve. Other than that it works great. Still a bit pricey for what you are getting, but if you need to have a stand alone valve (and I do) it is worth the money vs the possibly mess to get power and wiring and a new interior controller. I would recommend it for that reason alone.

This is a replacement for another that failed. I think for the price, they should last longer but, they have always worked flawlessly up to that point. They are pricey. This one is a newer design that I like better if you want to turn on manually. I've used this same timer on up to 2" pipe and irrigated thousands of trees.

Useful when you have no wiring to a wall-mounted controller available. The programming is not very intuitive, but once its set up, it works well.Im not that handy, but I was able to install this pretty easily. The 2-station doesnt include a solenoid, so you have to order one separately and wire it up.

Great product,easy to program.

Old controller died. This was the replacement and worked with our system very well.

The two 9v batteries lasted9 months so should swap afterLess than that. The nice thing was the program was still saved afterBatteries went dead. I did not have to reprogram as I expected. Nice feature but battery life in my system was just ok

works perfectly

Without the silinoes is not a good idea to buy. Using tape to connect wires is not the best.

Awesome if you have no power. so far they have been performing great!

Works well

Works great difficult for me to set up.

We live at a place where we have a HOA breathing down our necks at all times. One day we noticed that our in-ground irrigation system went off on a day that it shouldn't. Our HOA puts pressure in the lines only on certain days and sometimes as they test our sprinkler systems by putting pressure in the lines on a day that there shouldn't normally be pressure. If your sprinkler system goes off on that test day, they'll fine you.Once I popped the old NODE100 out of the ground I noticed that the display had water bubbles in it. If I tried to wake it up, it would respond incredibly slowly. Then, if I tested it, it would completely "crash" and would not respond to any inputs; I had to remove both 9 volts and replace them to get it to boot up again. At this point I knew that the water proof seal of the timer had been purged and it was shorting it out. The circuit board is completely potted and is not accessible without destroying it. I had no choice other than to replace it.I shut off the line by twisting the solenoid shut and ordered this timer as an exact replacement. It took a while to arrive but, it was well worth the wait. I set the timer to run for 30 minutes even through our HOA puts pressure in the lines for an hour. This is so my daughter can make it to the bus in the morning without getting drenched.This sprinkler timer has been working great for a couple months now. Its a little confusing to set up because, you can customize a lot about how it works. However, Hunter has a series of YouTube videos that will help you set up every aspect of this timer to how you want. Expect to have to check the batteries every year and expect the water proof seal to break after a couple years, however.